base board for RadiusMaster Dimensions 625x460x8 mm heavy-duty made from steel, powder-coated, with 2 rolls for easy moving in the workshop

Mounting plate for RadiusMaster for adjustable tool rest (672109) or hollow grinding jig (672110)

adjustable drive wheel tool rest for RadiusMaster   Once the mounting plate (optional accessory #672108) is installed under motor base this adjustable tool rest can be fitted or removed in 5 seconds or less. It allows heavy metal removal much faster and smoother than grinding against the steel platen. Rest is adjustable to keep edge of different thickness materials square or any angle down to 45º. No tools needed for adjustment.

hollow grinding jig without mounting plate for RadiusMaster optional accessory: mounting plate #672108

Platen table for square edge grinding for RadiusMaster

  contains: - Frequency converter - Connection cable 2 m including plug - shielded cable 2 m   Mounted and parameterized ready to plug in - "Plug and Play"   With this set you can turn the three-phase Radiusmaster (400V/3-ph) into a speed-adjustable belt sander. Enables delicate, precise and slow grinding, sharpening or polishing of knives or other workpieces.   Advantages: adjustable belt speed Belt speed approx. 3.6 to 19.2 m/s robust IP66 design   Why THIS solution? The speed of an electric motor can be controlled with a frequency converter. This means that the speed of belt-grinder can be adapted to the current situation.   Advantages of using an FU: Increasing energy efficiency (savings) Reduced wear of components Lower starting currents   Frequency converter instead of speed controller: A frequency converter changes the frequency of the current and thus the speed of the rotating field - ideal for speed control. The technically clean solution ensures lower power consumption. A simple “dimmer” for incandescent lamps is often used as an inexpensive speed controller. These “dimmers” do nothing other than not allowing a certain part of the sine curve to pass through. “Dimmers” cut the phase on or off. There is a lot of slip and the speed fluctuates greatly. With this method, the overall efficiency drops significantly and almost as much electricity is required as in nominal operation. Furthermore, the engine will wear out more quickly.     Available in 2 variants for 230V/1ph or 400V/3-ph input voltage. Not suitable for Radiusmaster 230V/1-ph.

capture device for RadiusMaster for connecting an industrial vacuum cleaner. consisting: high-strength, flexible hose ø 80 mm made of stainless steel, length approx. 900 mm adapter for connecting an industrial vacuum cleaner ø 61.5 mm stand with height-adjustable bracket   Suction unit with flexible segment hose made of stainless steel. Connects to a central vacuum system or an industrial vacuum. Please observe the relevant safety instructions for your industrial vacuum cleaner regarding the risk of explosion and fire.

  Splash-proof coupling and plug, For permanent use outdoors as well as on construction and assembly sites