bottom anvil tool 50 mm
shank/pin end 25 mm
The finishing hammer is used for smoothing forged surfaces and for precise alignment. It is fixed in the square hole, and its ground face provides a flat surface for accurate results.
Application: Smoothing and aligning (e.g., knife blades) while hot after rough forging.
Function: Eliminating structural irregularities for a clean surface finish
Fixation: In the square hole of the anvil or vise
Special feature: Flat, ground working face
Tip:
Ideal for straightening knife blades or when the anvil face is worn.
Information on product safety:
- Use only for users familiar with the product.
- Only for the intended purpose.
- Improper use can lead to damage and injury. Please also note the safety instructions included with the product.
Importer/manufacturer/distributor (unless another manufacturer is explicitly mentioned for the article):
ANGELE GmbH | Ringstrasse 25 | 88416 Ochsenhausen | Germany
info@angele-shop.com
Information on product safety:
- Use only for users familiar with the product.
- Only for the intended purpose.
- Improper use can lead to damage and injury. Please also note the safety instructions included with the product.
Importer/manufacturer/distributor (unless another manufacturer is explicitly mentioned for the article):
ANGELE GmbH | Ringstrasse 25 | 88416 Ochsenhausen | Germany
info@angele-shop.com