Mold release agent Spray
€28.00*
Available in about 14 days
Special spray for minimizing adhesion of models and molds
Contents 500 ml
Environmentally friendly release agent for demolding various molding sands.
Properties:
· Environmentally friendly release agent
· Low viscosity
· Easy spraying
· Uniform release layer formation
· High yield
· Thin coating sufficient for models
· Economical in use
· Excellent release properties
· Low odor
Application:
The model or workpiece must be dry, dust-free, and grease-free.
1) Shake the spray can vigorously for approximately 30 seconds.
2) Spray the model evenly with a thin layer.
3) Allow the model to dry and then mold it.
Our parting agents ensure optimum process reliability due to clean demoulding and are extremely economical in use
Information on product safety:
- Use only for users familiar with the product.
- Only for the intended purpose.
- Improper use can lead to damage and injury. Please also note the safety instructions included with the product.
Importer/manufacturer/distributor (unless another manufacturer is explicitly mentioned for the article):
ANGELE GmbH | Ringstrasse 25 | 88416 Ochsenhausen | Germany
info@angele-shop.com
Information on product safety:
- Use only for users familiar with the product.
- Only for the intended purpose.
- Improper use can lead to damage and injury. Please also note the safety instructions included with the product.
Importer/manufacturer/distributor (unless another manufacturer is explicitly mentioned for the article):
ANGELE GmbH | Ringstrasse 25 | 88416 Ochsenhausen | Germany
info@angele-shop.com